Bad Piggies Flight in the Night Bonus Level 4-VIII Walkthrough

Bad Piggies Flight in the Night Bonus Level 4-VIII (4-8) can be 3-starred with a single contraption. Use a basic metal airplane, but put the wooden wheel in the center instead of the front. It may be worthwhile to try to unbalance the weight, overloading the rear of the plane. Using the TNT to push the plane up may be necessary.

If you have a different strategy for completing this level feel free to leave a comment below.

Hidden Skull Alert!

Tags: BP Walkthrough, FITN Bonus Level, Flight in the Night
Category: 04. Flight in the Night, Bad Piggies, Walkthroughs

    Comments (4)

    Rank: Gold Flinger with 9325 points
    By f91jsw (@f91jsw)

    It’s also possible to fly directly to the finishline by not using any wheel at all. Place two springs on the ground at the lower right corner, and start with the plane as high as possible. At take off the plane will drop, bounce off the springs and then become airborne.

    Rank: Pig Leader with 12045 points
    By kai92 (@kai92)

    I got 3 stars with same design as video but put engine at left, piggy at middle, and egg on right.

    Rank: Master Slinger with 6675 points
    By TheBirdBrain (@thebirdbrain)

    I got 3 stars without needing the TNT to propel the plane upwards. Place the egg where the pig is in the video, the engine in the middle and the pig in the left. The wheel should go to the right instead of the center. You have to time it so that the top part of the plane doesn’t clip the top wall.

    When done right you should be able to reach all the way to the top above the TNT. The wheel will catch on the cliff but then the plane will straighten. After that it’s pretty simple to grab the star and hit the finish line.

    By sygxp

    Mine setup is easier.
    It’s a “L” on top of 2 TNT,egg on the top so it won’t blow away.Piggie under the egg.
    One spring to the right side of the right TNT,with the steel wheel.
    One spring under the left TNT,with the wooden wheel.
    The trick is the wheel won’t attach to the TNT,you have to use the springs to connect them.

    Leave a Reply

    Your email address will not be published. Required fields are marked *