Tag Archive for: AA Week 3

Amazing Alex SPARE TIME Level 8 Week 3 Walkthrough

Amazing Alex Level 8 for Week 3 (October 29) is called “SPARE T/ME”. This level looks far worse than it actually is. Angle the top bowling ball leftward. After it lands on the switch, it will...

Categories
Tags
3

Amazing Alex Cursed Rides Level 7 Week 3 Walkthrough

Amazing Alex Level 7 for Week 3 (October 29) is called “Cursed Rides”. First, place the Bad Piggy Bank in the top-left corner. Do a few dry runs to make sure it pushes the remote under the...

Categories
Tags
2

Amazing Alex The 3 chains help Level 6 Week 3 Walkthrough

Amazing Alex Level 6 for Week 3 (October 29) is called “The 3 chains help”. Place a pretty pink balloon under the bottom-left star. Tie a rope around the doll’s waist and pull it off...

Categories
Tags
4

Amazing Alex They see me rollin Level 5 Week 3 Walkthrough

Amazing Alex Level 5 for Week 3 (October 29) is called “They see me rollin'” (They hatin’?). Place the boxing glove facing upwards in the bottom-left corner to push the 8-ball along....

Categories
Tags
0

Amazing Alex down and down Level 4 Week 3 Walkthrough

Amazing Alex Level 4 for Week 3 (October 29) is called “down and down”. This level is almost a bit too simple for the episode, but nonetheless, our strategy appears below. Mix between using...

Categories
Tags
0

Amazing Alex 3-2-ball Level 3 Week 3 Walkthrough

Amazing Alex Level 3 for Week 3 (October 29) is called “3-2-ball”. Position an elbow to roll the marble rightward. If it falls into the central area, it should automatically roll down the pipe...

Categories
Tags
0

Amazing Alex Les aimants Level 2 Week 3 Walkthrough

Amazing Alex Level 2 for Week 3 (October 29) is called “Les aimants” (French for “Magnets”). Place all four magnets in a row just left of the lamp shade. Place the scissors so the...

Categories
Tags
0

Amazing Alex Ne t’arrete pas Level 1 Week 3 Walkthrough

Amazing Alex Level 1 for Week 3 (October 29) is called “Ne t’arrete pas!!” (French for “Do not stop!!”). Complete the pipping as you normally would, then position the magnets...

Categories
Tags
0